Installation Instruction

2
Glass Bae
Glass
Screw
Wire Connector
Fig.1
D1
E1
A1
B1
C1
Junction Box
Mounting Backplate
Ground Wire
Driver
Mounting BackplateMounting Screw
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
3. Remove the mounting screw (C1) from the xture.
4. Secure the mounting back plate to the junction box using the junction box screw (B1).
The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRE (FIG. 2)
5. Connect the driver input/output wire to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground
wire directly to the back plate using the green screw provided.
After wires are connected, tuck them carefully inside the junction box.
*Require driver to be recessed within the junction box.
MOUNTING THE FIXTURE (FIG. 1)
6. Slide the glass onto the xture, secure the glass bae (D1)
to the xture with screw (E1).
7. Place the xture over the mounting plate with mounting screw (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
1 3/4”
6 5/8”
1 3/8”
4 1/8”
Back Plate Dimensions
INSTALLATION INSTRUCTION
Vanities & Sconces