Installation Instruction

SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. FIRMLY ATTACH THE FIXTURE GROUND WIRE (BARE COPPER) TO THE MOUNTING BRACKET WITH
THE GROUND SCREW (BY WRAPPING AROUND THE GROUND SCREW) AND THEN CONNECT IT TO
THE HOUSE SUPPLY GROUND WIRE WITH A WIRE NUT.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A
CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
White
Black
House supply
Ground wire
Fixture
Ground wire
Star
Washer
Cap
Nut
Cap
Nut
1. Mount the mounting
bracket to electrical box using
electrical box screws. Make sure
the studs on the mounting
bracket are facing out from the
electrical box.
2. Position mounting bracket
so that the fixture will sit level
once it is mounted to the wall.
Tighten screw to hold in place.
3. Firmly attach the fixture
ground wire (bare copper) to
the mounting bracket with the
ground screw (by wrapping
around the ground screw) and
then connect it to the house
supply ground wire with a wire
nut. Connect the black wire
from the fixture to the black
wire in the electrical box and
connect the white wire from
the fixture to the white wire in
the electrical box.
Electrical Box Screws
(not included)
Mounting
Bracket
4. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
electrical box making sure no bare
wire (on the black and white) is
visible at the wire nuts.
5. Position fixture over studs on
mounting bracket assembly.
Secure fixture in place with star
washers and cap nuts.
6. Install specified bulb type
and wattage (not included).
7. After installation, seal around
the top and side perimeter
between the fixture and the wall
surface with weather resistant
caulking. The bottom should be
left un-caulked to prevent
moisture build-up. Apply a small
amount of weather resistant
caulking around the side
perimeter between the cap nut
and mounting plate.
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Wiring supplies
as required by
local electrical
code
Electrical
Box
Electrical
box
Studs
Ground
screw
Screw
Stud
OUTDOOR
LIGHTING
Stud
Weather Resistant
Caulking
(not included)
Bulb
Fixture
PHOTOCELL FEATURE: ACTIVATE THE BULB SHUTOFF
AUTOMATIC DAYLIGHT AND REACTIVATION OF THIS
SHUTOFF AUTOMATIC AT NIGHT.