Installation & Assembly

LED SAUCER FIXTURE
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CAUTION - RISK OF ELECTRIC SHOCK. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT
BRANCH CIRCUIT CONDUCTOR.
4. WARNING, THIS IS A LINE VOLTAGE MODEL AND DOES NOT AND CANNOT USE A DRIVER.
5. LINE VOLTAGE MODELS ALREADY HAVE A POWER SUPPLY CHIP BUILT INTO THE LED ARRAY.
INSTALLATION
1. Gently push the diffuser
4. Line up magnetic PCB
down at one side to move board with mounting holes
the diffuser further inside on metal pan.
at one side of fixture to Attach fixture to mounting
create an opening gap screws, turn fixture
between diffuser and fixture. counter-clockwise to lock.
Then gently slide the opening
gap to lift the diffuser out.
2.Place mounting screws 5.Secure fixture by
(included) in electrical box tightening mounting
screwing in halfway. screws.
6.Gently fold diffuser a
3. Using wire nuts to connect
little bit to insert it into the
ground wire (green) from curve of the fixture. When
fixture and LED board to the entire diffuser stays
ground wire from electrical box. inside of the fixture, gently
Connect black wire from fixture move the diffuser to make
to black wire from electrical box. the diffuser average along
Connect white wire from fixture the edge of fixture.
to white wire from electrical box.
This LED Light is suitable to be dimmed
MAGNETIC PCB BOARD MAY SHIFT OR MOVE DURING SHIPPING
PLEASE ADJUST AND OR CENTER THE PCB BOARD