Installation Manual

ManualsBrandsOrpak Systems ManualsElectronicsnWGT-W Outdoor unit w/p.s., nWGT-W Outdoor unit w/o p.s, nWGT-W (Pump, SAMx1, LAN)

Table Of Contents

8. The final installation appears as follows (see Figure B-16):

Figure B-16 - Cable Gland Completed Installation

B.4. Top/Side-Mounted Flat Installation

To install the nWGT lying flat against the top/side of a dispenser without a bracket, proceed as follows:

1. Drill a 22.5mm hole in the surface and route the cable bundle through the hole, and use the

rubber seal to determine where to drill holes for the four screws (see Figure B-17):

nWGT Installation Manual 39