Installation Manual

Use a pneumatic (non-electric) drill for all necessary drilling
If no pneumatic drill is available, remove the section of the dispenser where the nWGT will be
installed, and perform the installation offsite in a safe location away from fire hazards
A.3. In-Dispenser Installation
CAUTION:Verify that the dispenser head enclosure is not made completely of metal as it
will block the RF transmissions. Ensure that there exists a gap of non-metal material to
allow transmissions to reach outside the dispenser head.
The nWGT unit is installed inside a dispenser with a bracket, and it can be installed in either a vertical
position (for bracket installation details, Top-Mounted Bracket Installation) or a horizontal position (for
bracket installation details, see section Wall-Mounted Bracket Installation). To install the nWGT inside of a
dispenser, proceed as follows:
nWGT Installation Manual 27