Installation Manual

Figure 4-7 - Current Loop Dispenser Interface Connected to nWGT Unit
4. Connect the harness to the required connector
5. Replace the front panel
6. Secure the front panel to the rear panel using the previously removed screws
4.3.3. Wall-Mounted Bracket Installation
This section describes how to install the nWGT unit on a solid wall such as a canopy support column.
Solid wall installation is Orpak’s recommended configuration. In cases where wall mounted bracket
installation is not possible, the nWGT may be installed on top, on the side, or inside of a dispenser if all
conditions are complied with. In-dispenser and On-dispenser installations are strongly not recommended
by Orpak.
To install the nWGT on a wall with a mounting bracket, proceed as follows:
nWGT Installation Manual 23