Installation Manual

ManualsBrandsOrpak Systems ManualsElectronicsnWGT-W Outdoor unit w/p.s., nWGT-W Outdoor unit w/o p.s, nWGT-W (Pump, SAMx1, LAN)

Table Of Contents

Figure 4-5 - Mounting Screws

4.3.2. Pre-Installation Steps

1. Remove the four M4x16 screws from the rear panel and keep for reuse

2. Remove the front panel

3. Connect the board to the CN8 and CN7 connectors in the PCB (see Figure 4-6, Figure 4-7):

Figure 4-6 - Optional Dispenser Interface Board Connectors

22 nWGT Installation Manual