User's Manual

Slide the adaptor over the spout.

Place it as close as possible to the

nozzle body

Choose the proper grip kit for the nozzle

(see rear table). Place a lid, the rubber ﬁller

and then the other lid

Secure the gip kit with the M4 screws.

Tighten them in stages and in a diagonal

sequence. Use a 3mm head ratchet

Apply glue and place the set screws in the

adaptor corners. Use a 2mm Allen key

Slide the nNR assembly over the spout

Secure the nNR to the adaptor with the M3

screws. Use a 2mm Allen key

Place the nNR front cover on top of the

assembly. Secure with the M3 screws.

Use a 2mm Allen key

Installation Kit

1 Set Screws 815221300 (6) 815221380 (8) 815221310 (10)

2 Spout Adaptor 814360500

3 Lids 814360424 (24) 814160427 (27) 814160430 (30) 814360700 (32)

4 Rubber Filler 814160024 (24) 814160027 (27) 814160030 (30) 814160032 (32)

5 M4 Screws 815213424

6 nNR Assembly 819260000 (nNR)/819260100(nNR + Switch)

7 M3 Screws 815260300

8 Front Cover 814360200

9 M3x6 Screws 815260200

# Part Name Part Number

Required Tools

2mm standard Allen key

(not ball ended)

3mm Allen head ratchet

(not ball ended)

Loctite 222/

Holdtite T43 glue

Unit should be serviced only by authorized

service personnel.

Program the unit

Opening of the unit by Service Personnel

must not be done at the location of installation.

When replacing the battery,

use only P/N 812560010.

Installation Notes

3mm

2mm

Qty.