Installation Manual

Figure 4-2 - Mounting Bracket
To install the TR500 with a bracket on top of the pump, proceed as follows:
1. Shut down any power source at the installation and working area
2. Locate a non-hazardous area to install TR500
3. Drill a 20mm hole 60mm-80mm behind the intended location for the TR500 to pass cables
through to the inside of the pump
4. Clean the surface intended for installing the TR500
5. Use a drill to install the mounting bracket on top of the pump (FIGURE TBD)
6. Use the two M3 x 10 screws provided to attach and tighten the TR500 to the mounting bracket
(FIGURE TBD)
4.2.3. Installation with Bracket on Top of Pump
The following table details the installation kit for installing TR500 on top of the pump (see Table 4-2):
P/N Description Quantity
814327191 TR500 WALL INST BRACKET 1
815225300 SCREW, M3x10+SPRING& FLAT WASHER 2
815228300 USER MANUAL, TR500 1
Table 4-2 - Top/Wall Mounting Kit - P/N 819027190
To install the TR500 with a bracket at any non-hazardous area on a wall near the pump, proceed as
follows:
1. Shut down any power source at the installation and working area
2. Locate a non-hazardous area to install TR500
3. Clean the surface intended for installing the TR500
TR500 Installation and Setup Manual 23