User's Guide

Mechanical Mounting using U-Bracket Supplied

The standard bulkhead mounting U-Bracket can be used to mount the ICS

NAV5plus above or below a horizontal (or near horizontal) surface.

• Use the U-bracket as a template to mark out the 4 fixing holes on

the mounting surface.

• Drill 4 off fixing pilot holes (1/8 inch / 2.5 mm diameter for

hardwood, or 3/32 inch / 3mm diameter for softwood or plywood).

• Use the No.10 S/S pozidrive screws supplied to attach the U-

Bracket to the mounting surface.

• Use the two 25 mm diameter rubber washers supplied between the

U-Bracket and the ICS NAV5plus case.

• Make the necessary electrical connections to the rear of the ICS

NAV5plus.

• Ensure that the two handwheel knobs are inserted through the

bracket and rubber washers on each end of the ICS NAV5plus.

• Hand tighten the knobs.