User's Guide

6
NAVTEX Stations Setup Procedure
When the key is pressed, the set up mode for the selected receiver will
be started. This enables the stations and message types required for that
receiver to be set. The two receivers are set up independently.
Station selection is displayed first:
Press followed by either the or the buttons, one push of either
button will select, a second push will deselect.
Deselected stations are indicated by a ‘dash’ (–).
Each NAVTEX transmitting station has its own identifying letter. A list of
these can be found in the NAVTEX Station Designations table section of
this manual (Appendix 1).
If you do not know which stations cover your area, start by leaving them all
stations selected. You will soon find which stations are relevant to you.
Press to store the NAVTEX station and message category selections.
STN: ABCDEFGHIJ
KLMNOP
Q
RSTUVWX