Installation Manual

89-041 Section 2 Issue 5 S2-5
Transponder
The Transponder consists of a backplate to which a Screw Terminal Board, the Transponder
module and the cover are attached. The Transponder is connected to the Screw Terminal
Board via ribbon cables, making the Transponder easily to disconnect without the need to
disturb the interface cables. This feature makes it very easy to interchange Transponders,
keeping repair time to a minimum.
Installation of the Transponder is made as easy as possible, as interface cables can be
connected directly to the built in Screw Terminal Board. The keyholes in the back plate make it
simple to attach the Transponder to a bulkhead.