Installation Manual

S7-2 89-041 Section 7 Issue 4
Note: The order of the following information is that in which it appears on the VDU
General Set-up
MMSI (Maritime Mobile Service Identity)
IMO (International Maritime
Organisation)
IMO
RAIM Present (Automatically Selected) Yes No
Set-up password (Max. 8 Characters)
Addressed message filter (Automatically
Selected)
On Off
Media analyser mode (Automatically
Selected)
On Off
Max. repeating message 6, 12 4 (default)
Transmission w/o sync Yes No
Enable deleting regions Yes No
Extra Set-up
Internal GNSS position Enabled Disabled
Distance Internal GNSS to Bow Metres
Distance Internal GNSS to Stern Metres
Distance Internal GNSS to Port side Metres
Distance Internal GNSS to Starboard Metres
Out position to MAIN & AUX Yes No
Alarm Signals
Tx malfunction On (default) Off
Antenna VSWR exceeds limit On (default) Off
Rx channel A malfunction On (default) Off
Rx channel B malfunction On (default) Off
Rx channel DSC malfunction On (default) Off
General failure On (default) Off
VDU connection lost On (default) Off
External EPFS lost On (default) Off
No sensor position in use On (default) Off
No valid SOG information On (default) Off
No valid COG information On (default) Off
Heading lost / invalid On (default) Off
No valid ROT information On (default) Off
No TDMA synchronisation On (default) Off
Tx Amplifier malfunction On (default) Off
No own reports mode On (default) Off