Operation Manual

M-2 AIS Operation Issue 1 7
Quick Start - setting to work
WARNING: The M-2 has no ON/OFF switch. It will automatically start operation
within 2 minutes of applying power to the transponder unit.
Caution: Read the warning notices at the front of this manual before powering
up the AIS Transponder.
When setting the M-2 to work, always review your vessel’s voyage related
information and update as required.
Starting the M-2
Apply the power source to the Transponder. This procedure will depend on the
vessel’s actual installation arrangements but would generally involve closing a
switch panel circuit breaker or switching on the AC / DC rectifier power unit (if
fitted).
After a short delay the Display Alert indication lamp (red LED) will start to flash
and shortly after that the Display start up welcome screen will be displayed.
Review and update your vessel’s voyage related information.
Check that the vessel’s navigation sensors are providing valid navigation
information.
Take particular notice that the heading information is in correct alignment with
the vessel’s master steering compass.
Consult the following sections for detailed system operation information.