Operation Manual

Page 25
8. To make a scan table containing the following entries:
Scan Program
01
Entry Channel
111
213
3 6
410
567
Press numeric key ‘1’ twice to enter
‘Channel 11’.
First press of the numeric key displays
1
second press displays 11. 2 seconds after
the last key press, the radio will move to the
next entry, ready for editing, so edit each
channel by pressing the numeric keys quickly.
9. The second entry is now highlighted
xxx
ready for editing (vacant channel entry
position). Enter
13 and wait for 2 seconds for
the radio to move down the list and highlight
the third entry.
If you make a mistake, or want to change an entry, use the Scroll Up key to
highlight and re-edit the entry, then continue adding entries as normal. (If the entry
you re-edited was several entries further up the list, use Scroll Down to move past
the correct entries until the first vacant entry position is again highlighted.)
10. Continue to enter channel numbers into
the remaining entries 3 to 5.
Press Store to save the Scan Program.
11. Display confirms Scan program stored,
then returns to the Edit scan program
selection screen.
You can either create/edit another scan
program (use the scroll keys to select Scan
Program
02, for example) or move up to a
higher menu level (or to the standby screen)
by pressing the Back / Exit key.
Scan: 01 edit
1:
xxx
Store Delete
Scan: 01 edit
1: 11
2:
xxx
Store Delete
Scan: 01 edit
5: 67
6:
xxx
Store Delete
Edit scan program
Scan:
01
Select Back