User's Manual

8 WALL BRACKET INSTALLATION

8.1 Siting

The wall bracket should ideally be sited in plain view near an emergency exit. When

choosing a suitable mounting position you should also consider:

• Ease of access in an emergency.

• Mount at least 1 metre (3’) from any compass equipment.

• Allow at least 25mm (1”) above the bracket for it to spring open.

• Allow 18cm (7”) for the antenna. Heavy bending of the antenna is bad.

8.2 Mounting procedure

The wall bracket is supplied with a set of stainless steel fixings 25mm (1”) in length.

The bracket mounts against a flat surface using 4 fixing points. Offer the bracket into

the chosen position and mark through the mounting slots. If you are using the nuts and

bolts supplied, drill 6mm (1/4”) holes in the centre of each mark. You will need a 4mm

Allen key to tighten the bolts. If the rear of the mounting surface is inaccessible then

use the self-tapping screws supplied and drill 3mm (1/8”) holes. Always fit washers

under the heads of the screws to avoid damage to the plastic.

175mm

(7")

130mm

25mm

(1")

29mm

(1.14")

59mm

(2.32")

55mm

(2.16")

240mm

(9.5")

115mm

(4.5")

(5.1")