Users Manual

PAGE 1
Oro Technology Co., Ltd. Al Sensor Tire Pressure Monitor System (TOMS) Sensor Assemblies maria ER RH 8 Read all instructions before installing. Refer to Mitchell Manual for installation specifications. Professional installation only. These Tire Pressure Monitor System Sensor assemblies are replacement or maintenance parts for motor vehicles that have a factory installed Tire Pressure Monitoring System (PMS.
PAGE 2
Install valve stem into the valve hole of the wheel Put on washer Install hexagonal nut into valve stem. Tighten the nut Use wrench to hold valve stem and keep vertical while Install sensor. Adjust the sensor to fit the drop well Finished of the wheel. Use wrench to keep stem vertical then tighten. Tighten the screw until 2.2Nm (Recommended Final Torque Setting) Transmitter Module Specification 40°C 10 125°C 30°C to 115°C 0 ~ 116 psi (or 0~800 kPa or 0~8 bar) +1 psi (or £7 kPa ; 0.
PAGE 3