User's Manual

c
Put the marked No. 1 tire sensor to the tire which is
marked No. 1. as step a. photo and follow steps:
1. Install the tire sensor to the valve.
2. Use the nylok screw and tighten up with the tire
sensor. (Pls. use the screwdriver which is
included to the accessories bag)
3. Adjust the tire sensor’s angle (paste on the
surface of the wheel), then tight up the nylok
screw with a torque wrench and please set 5
Newton for torque wrench.
4. Put on the valve’s cap, and finish the
installation.
When there is a need to re-install the tire sensor,
please use a new nylok screw in order to prevent
the usage of the old ones.
d
Place the No. 2 tire sensor to the tire which is
marked No.2, and set up the other 5 sensors in the
same manner as shown in the step C.
e
Make sure there is no other liquid or dust present
around the area of the tire sensor.
f
After installation, inflate the tire to the appropriate air
pressure as suggested in each vehicle’s user
manual.
g
Balance the tires with the tire balance machine。
h
Place the tires back to it’s corresponding position as
shown in the photograph on step a.