User's Manual

6. Set up for No.6 tire sensor:
The tire No.6 symbol will be flashing green on the display. This means the No.6 tire is ready for
the set up as per below, Fig.1, in the meantime, the user should deflate the tire pressure rapidly
over 0.3 bar/30 kPa or 4 psi within 15 sec. until there is a beep sound, which means the user has
completed the set up for No.6 tire. The system will then proceed to tire No.7 sensor setup mode as
shown below Fig. 2.. If there is no need to set up tire No.6 sensor, just press the SET button to
skip this process.
Fig. 1 Fig. 2
7. Set up for No.7 tire sensor:
The tire No.7 symbol will be flashing green on the display. This means the No.7 tire is ready for
the set up as per below, Fig.1, in the meantime, the user should deflate the tire pressure rapidly
over 0.3 bar/30 kPa or 4 psi within 15 sec. until there is a beep sound, which means the user has
completed the set up for No.7 tire. The system will then proceed back to the normal display mode.
If there is no need to set up the No.7 tire sensor, just press the SET button to skip this process.
The system will then proceed back to the normal display mode, without any changes.
Fig. 1
Mode 2 ：Single Sensor Replacing
The user should confirm whether the all sensors are manufactured by ORO before carrying out
any changes or replacement, if not, the user will not be able be succeed on set up or make the
system operate normally.
The monitor will display No. 2 in blue which means the system is in Mode 2.
Choose a sensor to be replaced starting from No.1 Tire -> No.2 Tire -> No.3 Tire -> No.4 Tire ->
No.5 Tire -> No.6 Tire -> No.7 Tire to complete the setup mode 2 and back to the normal operating