User's Manual

Fig. 1 Fig. 2
4. Set up for No.4 tire sensor:
The tire No.4 symbol will be flashing green on the display. This means the No.4 tire is ready for
the set up as per below, Fig.1, in the meantime, the user should deflate the tire pressure rapidly
over 0.3 bar/30 kPa or 4 psi within 15 sec. until there is a beep sound, which means the user has
completed the set up for No.4 tire. The system will then proceed to tire No.5 sensor setup mode as
shown below Fig. 2.. If there is no need to set up tire No.4 sensor, just press the SET button to
skip this process.
Fig. 1 Fig. 2
5. Set up for No.5 tire sensor:
The tire No.5 symbol will be flashing green on the display. This means the No.5 tire is ready for
the set up as per below, Fig.1, in the meantime, the user should deflate the tire pressure rapidly
over 0.3 bar/30 kPa or 4 psi within 15 sec. until there is a beep sound, which means the user has
completed the set up for No.5 tire. The system will then proceed to tire No.6 sensor setup mode as
shown below Fig. 2.. If there is no need to set up tire No.5 sensor, just press the SET button to
skip this process.
Fig. 1 Fig. 2