User's Manual

8
Warning Situation: When the tire sensor
experiences failure when on factory default.
Warning System: The affected tire will display a
reading of E3.
NOTE: 1.The user can press the MODE button continuously for 3 sec. to stop the warning sound.
TR01 Reset for Tire Changing and Rotation
Upon completion of changing or rotation of tires, the user should also reset the position of the tires
on the display unit. ORO-TR01 has provided 3 modes where users can reset quickly and keep the
tire position as it in on the display unit.
The user should ascertain that the display is plugged in, when carrying out the tire
changing/rotating mode, if the power is interrupted, please follow the reset process in order to
proceed successfully. The user should confirm whether the display is able to monitor all the tire
information correctly, if not, please carry out the reset process
Set Up Process for Enter the Tire Changing and Rotation
Depress the SET and Mode button simultaneously for 3 sec., and the system will enter set up
mode 1, pressing once each time will allow the user to traverse from mode 1 to mode 3 and back
to normal display.
Description for each set up process
Mode 1 ：Random Repositioning
The user should install the tire to their desired position before entering mode 1. When the display
shows a blue “1”, this means that it is in mode 1.
Reset starting from No.1 Tire -> No.2 Tire -> No.3 Tire -> No.4 Tire -> No.5 Tire -> No.6 Tire ->
No.7 Tire in order to complete the setup mode 1.