User's Manual


5



3. Put on the circle screw (washer)from
the outside of the wheel.






4. Tighten the valve with the nylok screw
from the outside of the wheel.






5. Use the alan key provided to tighten.
c
Put the marked No. 1 tire sensor to the tire
which is marked No. 1. as step as. photo
and follow steps:
1. Install the tire sensor to the valve.
2. Use the nylok screw and tighten up with the
tire sensor. (P lease use the screwdriver
which is included to the accessories bag)
3. Adjust the tire sensor’s angle (paste on the
surface
of the wheel), then tight up the with the
nylok screw.
4. Put on the valve’s cap, and finish the
installation.
When there is a need to re-install the tire
sensor, please use a new nylok screw in
order to prevent the usage of the old ones.
