User's Manual



Fig. 1 Fig.



4. Set Up for Left Front (LF) Tire Sensor

The LF tire symbol will be flashing green with a blue “4” on the display. This means the LF

tire is ready for the set up as per below, Fig. 1, in the meantime, the user should deflate the

tire pressure rapidly over 0.3bar/30kPa or 4 psi within 15 sec. until there is a beep sound,

which means the user has completed the set up for LF tire. The system will then proceed

back to the normal display mode. If there is no need to set up the LF tire sensor, just press

the SET button to skip this process. The system will then proceed back to normal display

mode, without any changes.



Mode 6: Single Sensor Replaced

Fig 1

The user should confirm whether the all sensors are manufactured by ORO before carrying

out any changes or replacement, if not, the user will not be able be succeed on set up or

make the system operate normally.

The monitor will display No.6 in yellow which means the system is in mode 6.

Choose a sensor to be replaced starting from Right Front Tire -> Right Rear Tire -> Left Rear

Tire -> Left Front Tire to complete the set up mode 6 and back to the normal operating mode.



1. Set Up for Right Front (RF) Tire Sensor

The RF tire symbol will be flashing green with a blue “1” on the display. This means the RF

tire is ready for the set up as per below, Fig. 1, in the meantime, the user should deflate the

tire pressure rapidly over 0.3bar/30kPa or 4 psi within 15 sec. until there is a beep sound,

which means the user has completed the set up for RF tire. The system will then proceed

back to the normal display mode. If there is no need to set up the RF tire sensor, just press

the SET button to skip this process. The system will then proceed to RR tire sensor set up

mode as shown below Fig. 2.