User's Manual

9



c
Pressing the
MODE button once, will increase
the cold tire pressure value by 1 unit; and the
unit increases by 1 psi with each press of the
button, when it has reached 50 psi, pressing
the button again will return the system unit to
27 psi.
NOTE: If the user choose kPa mode, 10 kPa
will be added with each press of the button, the
range for kPa is 190kPa~350kPa, and 1.9 bar
~ 3.5 bar for bar unit.

d
Press the SET button to complete the Front
Tire-Standard Cold Tire Pressure Setting. The
system will automatically enter the Rear
Tire-Standard Cold Tire Pressure Setting Mode.


Rear Tire-Standard Cold Tire Pressure Setting Mode

Steps Operating Process Photographs
a
The system will enter the Rear Tire-Standard
Cold Tire Pressure Setting Mode automatically
after setting up the Front Tire- Standard Cold
Tire Pressure setting.

b
The wireless receiver and display unit shows the
standard cold tire pressure. The factory default
value (35psi) is shown in blue and the yellow
light indicates the ”psi”. or pre-selected units( kPa
or bar). If no modification is needed, press the
SET button to enter the next setup mode.
NOTE: If the pressure unit is in ”kPa” the
display will flash 250 and 2.5 for ”bar”.

c
Pressing the MODE button once, will increase
the cold tire pressure value by 1 unit; and the
unit increases by 1 psi with each press of the
button, when it has reached 50 psi, pressing
the button again will return the system unit to
27 psi.
NOTE: If the user choose kPa mode, 10 kPa
will be added with each press of the button, the
range for kPa is 190kPa~350kPa, and 1.9
bar ~ 3.5 bar for bar unit.

d
Press the SET button to complete the Rear
Tire-Standard Cold Tire Pressure Setting.
The system will automatically enter the Tire
Temperature-Over Temperature Setting Mode.
