User's Manual

4. Tighten the valve with the nylok screw from the

outside of the wheel.

5. Use the alan key provided to tighten.

Put the marked No. 1 tire sensor to the tire which is

marked No. 1. and follow steps:

1. Install the tire sensor to the valve.

2. Use the nylok screw and tighten up with the tire

sensor. (Please use the screwdriver to lock the

nylok screw using 2.2N．m (22.4kg．cm) torque)

3. Adjust the tire sensor’s angle (paste on the

surface of the wheel), then tighten up with the

nylok screw.

4. Put on the valve’s cap, and finish the installation.

When there is a need to re-install the tire sensor,

please use a new nylok screw.

Place the No. 2 tire sensor to the tire which is

marked No.2, and set up the other sensors in the

same manner as shown in the step C.

Make sure there is no other liquid or dust present

around the area of the tire sensor.