User's Manual

W410 TPMS Installation
1. Please enter the default set mode before installation to set up required Tire Pressure value
for the vehicle. The default pressure value of W410 is 35psi (2.4bar). The warning system
will alarm when the tire pressure is higher or lower than 25% of set up Tire Pressure value.
2. The tire temperature will rise simultaneously with Tire Pressure in normal driving
conditions. In cold weather conditions such as 6℃ (10℉) the tire pressure may drop
1psi or more. Always check that the psi is within the recommendations of the vehicle’s user
manual.
NOTE: The standard Tire Pressure set value shall following vehicle manual or placard data.
3. Display Installation
a. There are 2 methods to install the display.
1. W410 Standing Adhesive Installation
2. W410 Windshield Adhesive Installation
b. Insert the cigar power cable to the plug on the back of display.
c. After decided the position of display, remove the 3M adhesive from the holder, the
angle of the display can be adjusted and fixed through the screwdriver.