User's Manual
FCC
This device complies with 3DUWRIFCC Rules. Operation is subject to the following WZR
conditions:
(1) WKLVGHYLFHPD\QRWFDXVHKDUPIXOLQWHUIHUHQFHDQG
(2) WKLVGHYLFHPXVWDFFHSWDQ\LQWHUIHUHQFHUHFHLYHGLQFOXGLQJLQWHUIHUHQFHWKDWPD\FDXVH
XQGHVLUHGRSHUDWLRQ
CAUTION
Any changes or modifications not expressly approved by the grantee
of this device could void the user's authority to operate the equipment.
System Scope of Use and Warnings
■System Installation and Usage
Use of the TPMS requires that qualified personnel according to the instructions here have
properly installed it. This system is suitable for use on a passenger car, SUV and 4X4 tires,
with up to maximum cold inflation pressure of 600kPa=87 psi (Gauge) or 700kPa=101psi
(Absolute). All instructions below use Gauge as a reference.
■Reacting to Alerts
When an alert or warning is received, reduce vehicle’s speed and proceed to a safe location
to stop where the tire can be inspected and /or serviced.
The low-pressure alert indicates that the air pressure has dropped to a selected minimum
while a high-temperature alert indicates that the temperature of the tire content has
surpassed the threshold value set.
Caution
The system is a wireless RF product and may not receive a signal due to poor environmental
conditions, incorrect operation or incorrect installation. When the system continuously cannot
receive any signal from any tire sensor for more than 10minutes since the system has been
switch on, the display will show “ E2 ” and activate the RED abnormal LED light along with an
alert sound. If moving the vehicle to a different location to eliminate RF interference does not
fix the problem, it is advised to take the car to a qualified tire maintenance center.