User's Manual

W410 Set for Tire Changing and Rotation
Upon completion of changing or rotation of tires, the user should also reset the position of the
tires on the display unit. W410 has provided 7 modes where users can reset quickly and keep
the tire position as it in on the display unit.
The user should ascertain that the display is plugged in, when carrying out the Tire
Changing/Rotating Mode. If the power is interrupted, please repeat the reset process in order
to proceed successfully. The user should confirm whether the display is able to monitor all the
tire information correctly, if not, please carry out the reset process.
Set up Process for Enter the Tire Changing and Rotation
Depress the SET button and MODE button simultaneously for 3 seconds. The system will
enter set up mode 1. Pressing once each time will allow the user to move from mode 1 to
mode 6 and back to normal display.
Description for Each Set up Process
When the display shows a yellow “1”, this means the display is now in mode 1 and the 4 red
lights means the tire position are not set as shown in Fig. 1. The 4 green lights indicates the
tire position that the user wants to set up as shown in Fig. 2. Press the SET button
continuously for 3 sec. until sounds beep indicating set up complete for mode 1. (Front and
Rear Tires Exchange) then the system will return to the normal operating display.
Mode 1: Front and Rear Tire Parallel Exchange
Mode 2: Tire Diagonal Exchanged
Mode 3：Front Tire Diagonal Exchange, Rear Tire Parallel Exchange to Front