User's Manual

2. Operation to Change Display Mode
W410 has 3 different modes. They are Tire Pressure Display Mode, Temperature Display
Mode, and Pressure-Temperature Alternate Mode. The display will show the tire pressure
mode once it is turned on. To enter the temperature mode press the MODE button once and
to display pressure-temperature press it another time. The system will continuously monitor
the tire pressure, tire temperature, battery voltage, no matter what kind of information is being
displayed and will notify the driver whenever anything abnormal happens. If the user does not
change from the factory default, the system will show the tire pressure display. The 3 modes of
display are as follows:
a. Pressure Display Mode: Display of 4 tires pressure and battery voltage unit only.
b. Temperature Display Mode: Display of 4 tires temperature and battery voltage unit only.
c. Pressure-Temperature Alternate Display Mode: Rotating display of tire pressure and
temperature with a constant display of battery voltage.
3. How to Change the Unit of Tire Pressure and Temperature
W410 displays 3 kinds of pressure units, bar, kPa and psi. For temperature, Celsius or
Fahrenheit can be displayed. To change the factory default for pressure or temperature, press
the MODE button for 3 sec.
4. How to Modify Factory Default
W410 has 4 factory default modes for users to choose from. Press the SET button
continuously for 3 sec. to enter the set up mode from Front Tire-Standard tire pressure set up,
Rear Tire-Standard tire pressure set up, Tire Temperature-Over Temperature Warning, and
Operation Mode. For other parameter settings, please refer below for the relevant process:
NOTE: The user should change the suitable pressure unit for own vehicle before entering into
the setup mode.
Set up Front Tire Pressure Value: Range 24psi~80psi (1.7bar~5.5bar), the default set
value is 35psi (2.4bar)
a. Press the SET button for 3 seconds to enter the Front Tire-Standard Tire Pressure Setting
Mode. The unit increases by 1 psi with each press of the button. When it has reached
80psi (5.5bar), pressing the button again will return the system unit to 24 psi (1.7bar).
b. The system will enter to Rear Tire Pressure Value Mode automatically by quickly
pressing the SET button.