Operation Manual

10
Troubleshooting
Do not disassemble or attempt to repair the machine yourself
Conditions Possible Cause and Solution
z The machine stops
during operation
and all four suction
power indicator
lights start
blinking together.
z Wait for about 30 seconds before you operate the
machine again. This lets the machine reset whilst you
identify one of the following possible causes.
z The water has turned very dirt and mirky. Empty the
water container and replace with clean water.
z The water level is above the maximum level. Reduce
the water level.
z The selected suction power level is too high for the
current cleaning application. Reduce the suction
power.
z The airflow is blocked. Remove the blockage.
z The machine does
not start
z AC supply is not properly connected the AC cord to
electrical supply.
z Noticeable
decrease in the
suction power
z The HEPA filter requires replacement. Change a new
one.
z There is a blockage. Remove the cleaning tools and
attachments from the machine and remove the
blockage.
z Leakage of water
when using for
cleaning of liquid
waste.
z The Switch Float is blocked. Unblock it by cleaning.