Operation Manual

http://www.orion.ua

1. Pilot lamp

2. Thermostat

3. Swing button

4. Rotary switch

5. Outlet wind

6. Base

1. Remove the Heater from the carton.

2. Place the heater on a firm level surface.

3. Set the main power to ‘Off’. Plug the cord set into a 220V electrical outlet.

4. The heater is equipped with 4-position rotary switch:

5. Set the rotary switch to maximum for fast warm up of a room. Once the temperature of room is

comfortable, select a lower setting to reduce electrical consumption and to prevent the room from

becoming too warm.

6. If you selected low or full output, choose the desired temperature with the thermostat. With the

Thermostat, the temperature can be regulated step by step.

7. When the desired temperature is reached, the unit will automatically switch off. Once the temperature

has fallen below the pre-set level, the heater will switch on again.

8. Pilot light will allow you to check the thermostatic regulation. When the appliance is heating, this pilot

light will be on. It will go out when the desired temperature is reached.

9. Before removing the plug from the socket, switching off and better work for 30-60 seconds with cool

air in condition that protecting inner parts.

This appliance also has the swing function. To switch the function on, press the swing switch. To stop it,

press the swing switch again.

SYMBOL FUNCTION

0 OFF

* Fan without heater

I 750W (Low heat output)

II 1500W(Full heat output)

OPERATING INSTRUCTIONS

SWING BUTTON

PARTS NAME