User`s manual

9
INSERTING/REPLACING THE HARD DRIVES IN
THE RAID UNIT
To assemble the RAID Unit, please follow the steps listed in the instructions
below:
1. Place the RAID Unit with its Bottom View facing you. Unfasten all four (4)
Casing Screws with a Phillips screwdriver. Afterwards, turn the RAID Unit to
its Cover side.
2. Lift the Cover upward to remove it. When opened, the PCBA boards (Printed
Circuit Board) should be securely in place inside the RAID Unit.
HDD Placement Holder
s
HDD Sc
r
e
w
s
Disk1
Disk2