User`s manual

4
PRECAUTIONS FOR THE RAID UNIT
GENERAL PRECAUTIONS
 The main circuit board of the RAID Unit is susceptible to static
electricity. Proper grounding is required to prevent electrical
damage to the RAID Unit or other connected devices, including the
host computer. Always place the RAID Unit on a smooth surface
and avoid all dramatic movement, vibration and percussion.
 Do NOT allow water to enter the RAID Unit.
 Do NOT place the RAID Unit close to magnetic devices (such as a
mobile phone), high-voltage devices (such as a hair dryer), or near
a heat source (such as on the dashboard of a car or any place
where it will be exposed to direct sunlight).
 Use only the power supply cable provided with the RAID Unit.
 Can use both 9.5mm or 12.5mm high 2.5” SATA HDDs inside the
RAID Unit.
 Do NOT attempt to service this RAID Unit yourself. Please contact
Technical Support regarding any parts other than ones mentioned
in the “Installation” section of this User’s Manual.
 Do NOT block the ventilation. Proper airflow is required to ensure
reliable operation and to prevent overheating.
 Do unplug the RAID Unit from the electrical outlet when not in use
to provide an ecological friendly environment.
RAID UNIT PRECAUTIONS
 Installation of RAID MASTER software in the host computer is
required for proper operation.
 Any loss, corruption, or destruction of data is the sole
responsibility of the user of the RAID Unit. Under no
circumstances will the manufacturer be held liable for the
recovery or restoration of any data.