User`s manual

REBUILD

If one of the HDDs fails, the Disk LED will become red, and the rebuild function

can be set up under RAID 1 mode. To setup Rebuild under RAID 1 mode,

please complete the following steps:

The use of identical HDDs from the same manufacturer, with the same

capacity and RPM is highly recommended.

1. When the failed HDD is removed, a popup window stating “Attention! Hot

Swap” will appear. Click on “Ok” icon to continue.

2. Another popup window will appear stating, “Attention! RAID 1 Degrade

Mode”. Click on “Ok” to continue.

When one of the HDD has failed, the Disk LED will become red. However,

no warnings will appear on RAID MASTER to notify the user. Please pay

attention to the Disk LEDs at all times.