The DL3 User Guide
Introduction Congratulations on your purchase of the DataLocker DL3™Encrypted Hard Drive. The DataLocker DL3™ stands alone as the only external hard drive equipped with a patented, on board, LCD touch screen. This feature allows the user to conveniently perform all processes directly through the LCD Interface, making it truly 100% platform independent.
Setting the User Password The DL3 supports the creation of a “User Password”. The user will have access to all data on the drive; however, the user will not be able to access certain Administrative Options. Note: You must change the default Administrator Password before creating a user password. Step 1: Enter the Administrator Password. Step 4: Press “CREATE”. A user with the default password of “000000” will be created. Step 2: Press the “SETUP” key on the touch screen.
Section III: Administrative Menu Options Change Password Used to set the Administrator Password User Password Used to create a User Password System Enter the System Menu Self Destruct Enables the Self Destruct Function and sets the maximum number of password attempts counter. The “Self Destruct” feature prevents brute force attacks. Once the defined number of failed password attempts is reached, all data on the DL3 will be irrecoverably destroyed.
Key Tone Turn the keypad tone on / off Zeroize Drive Initiates the destruction of all encryption keys and user passwords, making the data on the drive unretrievable. The DL3 will be reset to factory original state. The DL3 will need to be reinitialized and formatted to be redeployed. RFID Enters the optional RFID Authentication module setup menu. Data Locker Link Enable the DL Link remote management system. For more information about this feature, please contact us directly at www.datalockerdrive.
Section VI: Setting up the RFID Authentication Module The DL3 features an optional RFID module for a 2nd factor of authentication. Step 1: After entering the Administrator Password, touch the “Setup” key Step 4: Place the supplied RFID tag near the bottom right hand corner of the DL3 until you hear a “beep”. Step 2: Touch the “System” menu option. Step 3: Touch the “=>” key to enter the second menu of system options. Select the “RFID” option.
FCC DECLARATION OF CONFORMANCE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
