Installation Instructions

9. Installing Tie Wires

Fasten the fabric securely with tie wires spaced

approximately 24" apart along the top rail and at

12" apart on each line post (Fig. 19). Twist ends

with pliers to avoid sharp points. Secure bottom of

fabric to tension wire at this point with wire clips

or hog rings. Finally, securely tighten nuts on all

rail end bands and tension bands.

Fig. 19

10. Installing A Gate

Step 2

Attach female hinges to gate frame. Loosely fasten bolts so they can be

easily adjusted on the gate frame. Hang gate(s) in place so that the

bottom of the gate has approximately 2 in. of ground clearance. Tighten

the bolts on the bottom female hinge first, then adjust and tighten the

bolts securely at the top.

Step 3

Position gate fork latch at a convenient height. Tighten all bolts securely.

Note: Adjust drop latch assembly on the double drive gate to

the correct

height and tighten all bolts securely (Fig. 21).

Note: You will need to leave 2 in. space between the post and the gate

on both sides of gate (drive gates need 2 in. space in the middle as well).

Single walk and double drive gates install with a similar

process (Fig. 20 & 21).

Step 1

Attach male hinges to gate post approximately 8"

from the top and bottom of the gate post with the

top hinge pin pointed down and bottom hinge

pointing up. This will prevent the gate from being

removed and/or from dropping off. Tighten all

bolts securely.

Fig. 20

Single Walk Gate

2 in.

Spacing

2 in.

Spacing

Fig. 21

Double Drive Gate

2 in.

Spacing

2 in.

Spacing

2 in.

Spacing

Rough Opening