User`s manual

SNBC CONFIDENTIAL
5. Usage of the Interface Module
5.1 Print Self-test Page
After the Interface Module is installed, refer to printer user’s manual to print self-test page.
The self-test information relative to Ethernet Interface is as below:
Explanation
Interface Type: the type is for Ethernet
Interface Firmware: shows the firmware version of interface module
IP Address: shows the currently used IP Address of interface module
MAC Address: shows hardware MAC Address of interface module
SUBNET Mask
GATEWAY
DHCP: shows if web-configuring parameters as IP Address are obtained by DHCP with
Disable or Enabled.
5.2 Device Search and Parameter Configuration
The tool of Net WinConfig.exe could search the Interface Module in Ethernet and configure it.
Before running the software, IP Address and Subnet Mask of host machine should be set
with same parameter of interface module in self-test page, and ensure host machine and the
interface module in same subnet.
The detailed usage of the software refers to the description documents.
5.3 Implementation of Printing Functions
Printer driver should be installed according to the description of the driver in printer user’s
manual and selects serial interface. After installation, the port of printer driver is reset to be
network port. The following shows the way to configure network port with BTP-2002CP
printer: