Instruction manual

MAINTENANCE

Before carrying out routine cleaning, switch off the fan and disconnect mains power. Use a soft, damp

cloth only and do not use abrasive substances.

NB. Do not submerge any part of the fan in the water.

TECHNICAL DATA

Power consumption: 55 W

Dimensions: 500 x 470 x 1350 mm

Weight: 3.55 kg

CAUTION

The symbol on the product means that at the end of its life, the appliance must not be considered

normal waste but hazardous waste and, as such, must be disposed of in specific recovery and disposal

areas, as prescribed by the EC Directive 2002/96/EC (WEEE). By disposing of this product correctly,

you can prevent negative consequences for the environment and for human health, due to the

presence of potentially hazardous substances in the product.

OPERATING

Place the appliance on a dry and flat surface. Operate the appliance with the noted power voltage

which was marked on the appliance (A.C. only). Do not immerse the appliance into water; use a damp

cloth to wipe the body and a dry one to wipe over the water. Note: please let the appliance cool down

fully before cleaning.

1.Plug the power cord set into a standard domestic

power outlet.

2.To make/stop the fan head oscillate, pushes down/pull

the clutch knob.

3.To adjust the airflow upward or mild downward, simply

adjust the motor head to desired angle by hand freely.

4.The height of the fan can be adjusted by loosening the

Height Adjustment Spinner. Ring carefully raising or

lowering the fan and firmly re-tightening the Spinner.

5.Speed is controlled by Speed switch( 4 settings: Off-I-

II-III)

Mounting the cooling fan (Fig. C)

1.Unscrew the spinner (16) clockwise and the nut (12) counter-clockwise then remove both of

them

2.Screw out the screw(19) and then fix Rear Guard (11) in proper position by tightening the

screw(19) with the screwdriver .(See Fig.C1)

3.Screw on plastic nut (12) tightly to attach rear guard (11)

4.Install Fan Blades (14) into Blade Holder (13) in the proper position

5.Cover Blade Holder Cover (15) and then fix onto motor shaft (10) (See Fig.C2)

6.Use Spinner (16) to attach blade set onto motor shaft (10) counter-clockwise

7.Set the Rear Guard (11) into the Front Guard (17) in the proper position

HANDLE

SPEED SWITCH

HEIGHT ADJUSTMENT SPINNER

CLUTCH KNOB

07 08