Baby Monitor Secure 50 User Guide
TABLE OF CONTENTS WARNINGS AND SAFETY INFORMATION 1 GETTING STARTED 3 YOUR BABY MONITOR 5 BASIC OPERATION 8 TROUBLESHOOTING 11 PRODUCT SPECIFICATIONS 12 GUARANTEE 13
WARNINGS AND SAFETY INFORMATION IMPORTANT 1 Do not place the cord in a high "wear and tear" location. Never use a frayed or compromised cord. Please read this user guide thoroughly before use. Your ORICOM Baby Monitor is designed to be an aid and should not be used as a substitute for responsible and proper adult supervision of a child.
2 WARNINGS AND SAFETY INFORMATION Battery requirements Each parent unit requires two rechargeable Ni-MH batteries, size AAA 1.2V 800mAh (HR10/44). • Do not dispose of the batteries in a fire, as they can explode. • Do not open, unscrew or temper with any of your baby monitor units or battery. Always carry out repairs through your authorised ORICOM representative or other duly qualified tradesperson. • Released electrolyte from the battery is corrosive and can cause damage to the eyes or skin.
GETTING STARTED Thank you for choosing this monitor from Oricom. Installation Your Secure 50 Baby Monitor offers the best Digital Technology. For the Parent Unit INTERFERENCE FREE FREQUENCY DECT (Digital Enhanced Cordless Telecommunications) is the most widely used worldwide digital cordless technology, offering amazingly clear sound, long range and maximum voice security. DECT operates on the 1.
4 GETTING STARTED 5 Press [ ] to turn the Parent Unit on. • Before first use, or if it has been out of use for a long time, the Parent Unit will need to be charged for 15-16 hours. During this time, the Parent Unit will operate from the Charger pod when switched on. Note that the Parent Unit cannot be used without batteries, even if it is placed in the charger. For the Baby Unit 1 In the event of a power failure, your Baby Monitor can switch to battery power.
YOUR BABY MONITOR Baby unit (Sender) 1 Night light Key Press to turn On the night light. Press again to turn off the Light. 2 Power On/Off Key Press to turn the Unit ON. Press and hold to turn the Unit OFF. 3 Page Key Press and hold this key, Parent unit makes an audible alert. Useful to call for assistance or to locate a missing Parent Unit. 4 Power light Red light glows when the power is On. A slow flashing light indicates batteries are low. 5 Microphone Picks up the sounds from your baby's room.
6 YOUR BABY MONITOR Left view of baby unit Parent unit (Receiver) 6 DC 6V input Connecting to Power Adaptor. 7 Battery Cover Rechargeable batteries. 8 Belt Clip 9 Volume Up/Down Keys Adjust the Volume at which you hear the sounds in your baby's room. 10 Power Key Press and release to turn it ON. Press and hold to turn it OFF.
YOUR BABY MONITOR 11 Power Light Red light when the power is ON. Flashing light indicates rechargeable batteries need recharging. 12 Battery/Noise Level Indicators Indicates the battery level or Noise level 13 Link Light Green light ON indicates “Linked” to Baby Unit. Flashing light indicates “Link” is lost. Charger Pod 14 Charging Light When Parent unit is placed in the Charger Pod, the red charger light comes ON to indicate the batteries are charging.
8 BASIC OPERATION Once you have set up your Baby Monitor, you will be able to hear the sounds in your baby's room through the Parent Unit. And also see the green and red sensor lights around the top of the Parent Unit rise and fall with the sound levels.
BASIC OPERATION • To stop the Page alert, press any button on the Parent Unit, or press [ ] again on the Baby Unit. Low Battery Note: If no button is pressed, the paging tone will stop after 30 seconds. If the Parent Unit volume is off, the Parent Unit volume will reset to mid volume. Baby Unit Night light The Baby Unit has a one touch night light which emits a soft starry glow, providing comfort and reassurance for your baby and allowing you to see them in a darkened room.
10 BASIC OPERATION 8 lights illuminated fully charged 6 lights illuminated half charged 4 lights illuminated battery is running low 2 lights illuminated (alarm beep sounds) batteries need recharging Note: The parent unit can be used on or off the charger pod. When on the charger pod, the batteries will be recharged at the same time. However, the time it takes to charge the batteries to full will be longer when the unit is charged and used at the same time.
TROUBLESHOOTING 11 Problem Possible cause(s) The red power lights do not turn on when you plug 1. Check if the units are properly connected to the power supply. in the power. 2. Check if the power is turned on. If not, Press [ ] to turn on the power. 1. You may have moved out of range. Move closer to the Baby Unit and wait 5 The green Link light on the Parent Unit is flashing seconds for the Link to establish. and cannot hear the sounds from your baby's 2.
12 PRODUCT SPECIFICATIONS Feature Specifications Operating Frequency DECT 1.8 GHz Range Up to 300m under optimum conditions. The range is reduced in buildings (up to 50m) as a result of walls, doors etc. Power supply (baby unit) Input: 240 VAC 50Hz Output: 6 VDC, 200 mA, Non rechargeable batteries (baby unit) (not included in the package contents) Type: AA, 1.
GUARANTEE 13 Warranty Information (Australia) Oricom makes no other warranties or conditions, express or implied, including as to merchantability and fitness for a particular purpose, except as stated in this Warranty. Any implied warranties that may be imposed by law are limited in duration to the Warranty Period. Oricom warrants that the product is free from defects in materials or workmanship during the Warranty Period.
Customer Support If you suspect your product is not functioning to specification, before making a warranty claim please use the following resources. - Troubleshooting Guide in this user guide - Online Frequently Asked Questions - www.oricom.com.au - Email our customer support team on support@oricom.com.au - Contact Oricom Customer Support team on 1300 889 785 or 02 4574 8888 (Monday to Friday 9am to 5pm EST) Please retain your purchase receipt and attach to the back page of this user guide. Visit www.
