TM Item # 315420994 Model # MS01A200XLA USE AND CARE GUIDE 2 FT. LED PLANT GROW LIGHT THANK YOU Thank you for choosing Orein! We hope you will continue to choose Orein in the future. Visit us online at www.orein-usa.com to see our full line of lighting products.
Table of Contents Planning Installation............................. 4 Tools Required ..................................... 4 Hardware Included............................... 4 Installation .................................................. 5 Table of Content ......................................... 2 Safety Information...................................... 2 Troubleshooting......................................... 2 Warranty ..................................................... 3 Pre-Installation........
Warranty WHAT IS COVERED The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of three (3) years from date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and service.
Pre-Installation Model No. MS01A200XLA Volts (V) 120 Watts (W) 100 Current(mA) 850 CAUTION - Receptacle 120VAC, MAX 5A DO NOT OVERLOAD PLANNING INSTALLATION WARNING: Shut off power at the circuit breaker or fuse panel before removing the old fixture. Product must be installed by a person familiar with construction and operation of the product and the hazards involved, in accordance with the applicable installation code. NOTE: Keep your receipt and these instructions for proof of purchase.
Installation – Suspension Mounting 1 2 Drill two holes in the ceiling with the spacing 18.1 inches. Unscrew the toggle (G) from the bolt (H). Unscrew the lock nut (I) from the hanging rope (E). I 18.1” E G H 3 4 Thread the bolt (H) through the lock nut (I), and screw the toggle (G) back on the bolt (H). Attach the hanging rope (E) to the lock nut (I) by screwing I H I E 2 1 G 4 3 5 WWW.OREIN-USA.
Installation (continued) 5 G 7 6 Press the toggle with your hand and thread the bolt through the holes. Release your hand after the toggle going through the holes, and the hanging rope will be secured. Attach the springs to the fixture. D G 8 Hang the fixture on the hanging ropes. 6 Plug the power cord (CC) into the power outlet, and use the zip-tie to fix the cord if necessary. Turn on the light with switch on the fixture.
Installation-Surface Mount 1 Drill two holes in the ceiling with the spacing 17.3 inches. 2 Use a hammer to knock the dry wall anchors (A) into the holes. 4 Use the screwdriver to remove the knock outs on the fixture. 17.3” 3 Screw the mounting screws (B) into the drywall anchors in the ceiling and leave a little gap 0.025-0.032 inches. R 0.025-0.032” 5 6 Align the keyholes with the mounting screws, and slide to secure the fixture firmly.
TM
