User Manual

1. Connect a source such as a Blu-Ray Player, game
console,A/VReceiver,CableorSatelliteReceiver,etc.
totheHDMIinputontheTransmittingunit.
2.ConnectadisplaysuchasanHDTVorHDProjector
totheHDMIoutputontheReceivingunit.
3.ConnectasingleCategory5e/6upto164ft/50mto
theoutputoftheTransmittingunit,andtheotherend
totheinputoftheReceivingunit.
4. For power, plug both the Transmitting unit and
Receivingunitwiththeincludedpowersupplies.
5. Power on each device in the same sequence
(receiver and transmitter will already be powered
wheneitherunitispluggedin.)
Atthispointthedisplayconnectedshoulddisplaythe
source signal connected to the extender set. If no
signal is being displayed, check the receiver EQ
swithcer.  If a display is having dificulty receiving a
signal,seeEDIDsectionandperformEDIDlearningor
access the display's menu and adjust the resolution
(lowesttohighestuntilsignalisdisplayed).A24Hz
7.CONNECTANDOPERATE