Product Manual

9
Safety Information
• NEVER split a log heavier than 100 lbs in horizontal position.
• ALWAYS set up the log splitter in a clear, level area. Failure to do so can result in instability of the log splitter.
• ALWAYS block the wheels to prevent movement of the log splitter while in operation.
• KNOW how to stop the log splitter and disengage the controls before operating it.
• NEVER place hands or feet between the log and splitting wedge during forward or reverse strokes as this could result in
serious injury or death.
• NEVER straddle or step over the log splitter during operation.
• NEVER reach or bend over the log splitter to pick up a log.
• NEVER split more than one log at a time.
• NEVER try to split a log across the grain.
• NEVER attempt to load the log splitter when the ram or wedge is in motion.
• NEVER use your foot, a rope, or any extension device to operate the control lever on the valve. Only use hand.
• NEVER move the log splitter while the engine is running. Shut off the engine if you are leaving the log splitter, even for a
short period of time.
• NEVER touch the muffler and hot areas of the engine during operation. Wait until the engine cools down.
General Repair
WARNING
• NEVER alter your log splitter in any manner. Such alterations may cause your log splitter to be unsafe and will void the
warranty.
• NEVER tamper with the engine to run it at excessive speeds. The maximum engine speed is preset by the manufacturer, and
is set within safety limits. Running the engine at excessive speeds will void the warranty. Refer to the engine owner’s manual
for your particular log splitter.
• NEVER perform any service or repair on your log splitter without first removing the spark plug wire.
• ALWAYS replace all damaged or worn parts immediately.
• ALWAYS be sure that all replacement parts meet manufacturer’s specifications.
CAUTION
• NEVER operate your log splitter when it is in poor mechanical condition or in need of repair.
• ALWAYS perform all recommended maintenance procedures before using your log splitter.
NOTICE
• ALWAYS check the level of hydraulic oil and engine oil before operation.
• ALWAYS periodically check that all nuts, bolts, screws, hydraulic fittings and hose clamps are tight.