Product Manual

18
Assembly Instructions
Step 3:
3a: Rotate tank tongue assembly on the crate base corner so that axles are clear of the base.
3b: Locate wheel assemblies, Flat washers, Castle nuts, Cotter pins and Dust caps from the hardware kit.
3c: Remove the protective cover from one axle shaft and the plastic cover from one wheel.
3d: Install the wheel (with the valve stem pointed out), outer bearing, flat washer, and castle nut.
3e: Tighten the castle nut until snug and rotate the wheel three full turns to seat the bearings.
3f: Back off (loosen) the castle nut just enough to align the hole in the axle with the notches in the castle
nut, allowing installation of the cotter pin. Do not loosen more than necessary to install cotter pin.
3g: Spin the wheel to verify it spins freely. Note: A small amount of play is acceptable.
3h: Insert cotter pin and split/bend the pin end left and right.
3i: Install the dust cap.
3j: Repeat steps outlined above for the other wheel installation.
1
2
13 14 15 16
Item Description Quantity
1 Tank Assembly 2
2 Wheel Assembly 2
3 Flat Washer 2
4 Castle Nut 2
5 Cotter Pin 2
6 Dust Cap 2