Cable Free Weather Station Model: BAR928 User Manual BAR928-E Cover R1 OP 1 Black 8/21/04, 11:55 PM
EN CABLE FREE WEATHER STATION MODEL: BAR928 USER’S MANUAL INTRODUCTION Congratulations on purchasing the BAR928 Top Weather Station. The BAR928 is an all-in-one clock and weather device. RF- controlled, it can automatically synchronize its current time and date when it is brought within an approximate 1500km radius of the radio signal generated from Frankfurt, Germany (DCF77). The BAR928 does weather forecasts and tells temperatures, indoors and outdoors.
EN H PRESSURE UNIT SLIDE SWITCH A LCD Selects between mb/hPa and inHg display Displays the current temperature monitored by the remote unit S MOON PHASE SCANNER B LED INDICATOR Displays the current moon phase or that of the date checked T U V W Flashes when the remote unit transmits a reading THERMO BUTTON Sets the unit in indoor or outdoor-remote temperature mode C °C/°F SLIDE SWITCH Selects between Centigrade (°C) and Fahrenheit (°F) MEMORY BUTTON Displays the maximum or minimum temperature
EN BATTERY INSTALLATION: MAIN UNIT - Strong 1. Gently press and lift the tab on the battery compartment door. 2. Insert four UM3 or AA-size batteries. - Weak - No signal - Receiving 3. Replace the battery compartment door. Replace the batteries when the BATT indicator on the weather forecast window lights up. HOW TO SET THE CLOCK MANUALLY When the current time is displayed, press MODE for three seconds. The 12-hr or 24-hr digits will flash. Use the UP or DOWN button to select either.
EN MULTILINGUAL DAY-OF-THE-WEEK NOTE ON OUTDOOR-REMOTE TEMPERATURE The display language of the day-of-the-week is selected in the calendar setting procedure. The foreign languages and their meanings are as follows: Language Monday Tuesday Wednesday Thursday Friday Saturday Once batteries are in place for the remote unit, it will start transmitting samplings at 30-second intervals. If no signals are received when the outdoor-remote temperature is selected, blanks will be displayed.
EN NOTE: HOW TO USE AND SCAN THE MOON PHASE 1. The accuracy of a general pressure-based weather forecast is about 70 to 75%, and therefore, cannot be held responsible for any inconveniences so caused by an inaccurate forecast. The BAR928 is equipped with a moon phase display and scanner with which eight moon phases are displayed on the screen from new moon to waning crescent. The one falls on the current day will flash on the screen. 2. The weather forecast is meant for the next 12 to 24 hours.
EN Temperature resolution HOW TO RESET THE UNIT : 0.1°C (0.2°F) Remote Temperature measurement The RESET button allows you to return all settings to its factory values. The button is required only when the unit is not operating in a favorable way, such as in the rare case of a malfunction. Displayed OUT temperature range : -50.0°C to +70.0°C (-58.0°F to 158.0°F) The RESET button is located inside the battery compartment door. To use the button, Proposed operating range : -5.0°C to +50.0°C (23.
EN CAUTION EC-DECLARATION OF CONFORMITY — The content of this manual is subject to change without further notice. This product contains the approved transmitter module that complies with the essential requirements of Article 3 of the R&TTE 1999 / 5 / EC Directive, if used as intended and the following standards have been applied: — Due to printing limitations, the displays shown in this manual may differ from the actual display.
© 2004 Oregon Scientific. All Rights Reserved.
