User guide

ManualsBrandsOregon Scientific ManualsThermometersWireless Weather Station With Temperature

Wireless Weather Station with

Temperature, Ice Alert and

Radio-Controlled Clock

Model: BAR386

User Manual

P/N: 300100700-00009-10 REV1

1/100

Summary of content (12 pages)

PAGE 1
Wireless Weather Station with Temperature, Ice Alert and Radio-Controlled Clock Model: BAR386 User Manual P/N: 300100700-00009-10 REV1 1/100
PAGE 2
Temperature ............................................................... 7 Temperature and Pressure Trend ............................ 8 Ice Warning ............................................................. 8 HI / LO Temperature Alarm ..................................... 8 Moon Phase ............................................................... 8 Reset .......................................................................... 9 Precautions ..........................................................
PAGE 3
EN BACK VIEW INTRODUCTION Thank you for selecting this Oregon ScientificTM Wireless Weather Station with Temperature, Ice Alert and RadioControlled Clock (BAR386). This clock is supplied with a remote sensor (THN132N) and can support up to 3 sensors in total (additional sensors sold separately). � NOTE Please keep this manual handy as you use your new product. It contains practical step-by-step instructions, as well as technical specifications and warnings you should know about.
PAGE 4
2. 3. 4. 5. 6. 7. 8. 9. / : Increase / decrease setting; activate / deactivate clock reception signal MODE: Change settings / display CHANNEL: Switch remote sensor display MEM: View current, maximum and minimum temperature °C / °F: Select temperature unit TEMP HI / LO : Change settings or enable / disable hi or lo temperature alarm for channel 1 RESET: Reset unit to default settings Battery compartment EU / UK switch 1. Sensor battery low 2. Ice warning is active 3. Pressure trend 4. Weather forecast 5.
PAGE 5
EN REMOTE SENSOR (THN132N) GETTING STARTED BATTERIES Insert batteries before first use, matching the polarity (+ and -). Press RESET after each battery change. � � � � � 1. LED indicator indicates main unit batteries are low. � � NOTE Do not use rechargeable batteries. We recommend that you use alkaline batteries with this product for longer usage and lithium batteries in temperatures below freezing. 1. Wall mount 2. Battery compartment 3. Battery door 4. Table stand 5. RESET 6.
PAGE 6
For best results: • Place the sensor out of direct sunlight and moisture. • Do not place the sensor more than 30 m (100 ft) from the main (indoor) unit. • Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture. • Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects.
PAGE 7
EN The clock collects the radio signals whenever it is within 1500 km (932 miles) of a signal. SENSOR DATA TRANSMISSION The sensor reception icon in the remote sensor area shows the status. ICON NOTE Slide the EU / UK switch to appropriate position for your location. Repeat each time you reset the unit. DESCRIPTION Main unit is searching for the sensor(s) NOTE Initial reception takes 2-10 minutes for first set up or when RESET is pressed. Once complete, the reception icon will stop blinking.
PAGE 8
WEATHER FORECAST This product forecasts the next 12 to 24 hours of weather within a 30-50 km (19-31 mile) radius based on barometric pressure trend readings. NOTE The time zone offset can be used to set the clock up to + / - 9 hours from the received clock signal time. If you have disabled the clock signal reception (i.e. manually setting the clock), do not set a value for time zone offset.
PAGE 9
EN To end auto-scan: Press CHANNEL or MEM. To set alarm ON / OFF: 1. Press and hold TEMP HI / LO . 2. Use and to select high / low temperature alarm. Press TEMP HI / LO to confirm. 3. Press / to set alarm ON / OFF and press TEMP HI / LO to confirm. 4. If alarm has been activated, use and to select the temperature. 5. Press TEMP HI / LO to confirm. To toggle between current, minimum and maximum records for the selected sensor: Press MEM repeatedly. To clear the records: Press and hold MEM for 2 seconds.
PAGE 10
Press RESET to return the unit to the default settings. NOTE Features and accessories will not be available in all countries. For more information, please contact your local retailer. PRECAUTIONS This product is engineered to give you years of satisfactory service if you handle it carefully. Here are a few precautions: • Do not subject the unit to excessive force, shock, dust, temperature or humidity, which may result in malfunction, shorter electronic life span, damaged battery and distorted parts.
PAGE 11
EN Calendar Power ABOUT OREGON SCIENTIFIC DD / MM language selectable: E, F, D, I and S 3 x UM-3 (AA) 1.5 V batteries Visit our website (www.oregonscientific.com) to learn more about Oregon Scientific products. REMOTE UNIT LxWxH If you’re in the US and would like to contact our Customer Care department directly, please visit: www2.oregonscientific.com/service/support.asp 96 x 50 x 22 mm (3.8 x 2.0 x 0.9 in) Weight 62 g (2.