User's Manual

EN
4
REMOTE SENSOR
20
23
21
1 2 3
Reset
22
19
19. LED status indicator
20. Wall mount hole
21. CHANNEL switch
22. RESET: Reset the unit to default settings
23. Battery compartment
GETTING STARTED
INSERT BATTERIES
1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (+/-).
3. Press RESET after each battery replacement.
LOCATION
MEANING
Clock/alarm area Main unit batteries
low
Outdoor temperature
area
ensor batteries low
REMOTE SENSOR
The main unit can collect data from up to 1 sensor.
To set up the sensor:
1. Open the battery compartment.
2. Slide the CHANNEL switch to 1, then press RESET.
3. Close the battery door.
4. Place the sensor within 98 ft (30 m) of the main unit
using the wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 5 ft (1.5 m) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
JW108_M_EN.indd 4 14-7-10 1:27