Product Manual

33
OREGON® Cordless Tool System
CHAIN SAW MODEL CS300
MAINTENANCE AND CLEANING
AA 1214 - F/N 573259
• Replace the guide bar and saw chain.
See “Assembling the Guide Bar and Saw
Chain” section in this manual.
• Tension the chain as described in
“Tensioning the Saw Chain” in the
“Unpacking and Assembly” section of
this manual.
CLEANING
WARNING: TO REDUCE THE RISK
OF INJURY, REMOVE BATTERY PACK
BEFORE CLEANING.
CAUTION: WHEN CLEANING
THE CHAIN SAW POWERHEAD, DO
NOT IMMERSE IN WATER OR OTHER
LIQUIDS.
Wear gloves and eye protection.
• Remove the battery.
• Remove wood chips and other debris
from the battery port. Make sure the
contacts are clean and dry.
• After use, clean debris from the saw
chain and guide bar. Wipe power head
with a clean cloth moistened with a mild
soap solution. Never use harsh cleaners
or solvents.
• Always clean out wood chips, saw dust
and dirt from the bar groove when
replacing the chain.
• Ensure that the chain tensioning gear is
free of wood chips and other debris.
BATTERY PACK
IMPORTANT: THERE ARE NO USER
SERVICEABLE PARTS INSIDE
THE BATTERY PACK. DO NOT
DISASSEMBLE.
Lithium ion batteries have a finite
operating life. If the amount of cutting
time per charge decreases noticeably, the
battery pack is at the end of its useful life
and should be replaced.
• Make sure the battery pack, including
the contacts, is clean, dry, and has no
signs of puncture, impact, or other
damage. Broken batteries can cause
fires or emit hazardous chemicals.
• Clean dirty contacts with a soft, dry cloth.
Dirt or oil can cause a poor electrical
connection, resulting in loss of power.
CHARGER
• Unplug the charger from the electrical
outlet.
• Clean dirty contacts with a soft, dry
cloth.
ADDITIONAL MAINTENANCE
INFORMATION
For further information on maintaining
the saw chain, guide bar, and drive
sprocket, consult the OREGON®
Maintenance and Safety Manual at http://
oregonproducts.com/maintenance/
manual.htm.