77224-01 REV C S I M P L Y A M A Z I N G® USER’S GUIDE XL21 LOANER VAC USA: 1-800-989-3535 CANADA: 1-888-676-7325 COMMERCIAL: 1-800-242-1378 www.oreck.com www.oreckcommercial.
1 2 10 11 3 4 12 13 14 ENFONCEZ JUSQU’À JUSQU’À ENTENDRE UN BRUIT PRESIONE HAST HASTA A ESCUCHAR UN CHASQUIDO DE SUJECI SUJECIÓ ÓN SUJECIÓN 20 21 22 23 24 SPECIAL 30 31 32 33 1 NORMAL 34
5 6 15 25 7 16 26 8 17 9 18 27 28 35 2 19 29
BEFORE OPERATING CLEANER, READ ALL INSTRUCTIONS IN THIS MANUAL CAREFULLY. IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: Table of Contents READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER Maintenance and Customer Service, Polarized Plug Notice, Accessories, Important Safety Instructions . . . . . . . . . . . . . . . page 3 Warranty, Troubleshooting Guide . . . . . . . . . . . . . . . . . . . . . . .
Warranty Troubleshooting Guide WARNING: Unplug cord from electrical outlet before servicing. ORECK MANUFACTURING COMPANY: (Oreck Manufacturing Company gives you the following limited warranty for this product only if it was originally purchased for residential use, not resale from Oreck or an Oreck Authorized Retail Dealer.) SAVE SERVICE CALLS...
Parts List Operating Instructions To assist you in identifying components of your vacuum, the parts have been numbered as follows: Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet and press the On Low (l) - On High (ll) - OFF(O) switch on handle assembly when ready to operate.
CAUTION—Wood Floors, Soft (Vinyl, Asphalt Tile, etc.) Floor Surfaces and Polished Floor Finishes Disposable Paper Filter Dust Bags Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the filter bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the filter bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner’s power.
Edge Brush Replacement WARNING: Unplug cord from electrical outlet before servicing. fig. 32 To reassemble, check O-ring on tube, and replace if damaged. Replace tube by first lining up slot at base of tube with tab inside fan housing. Insert tube and push down until the tube is seated. Make sure O-ring is in place against fan housing opening. Replace and tighten collar until collar locking tabs are locked in place. Reattach bag spring (fig. 31) fig. 25 Turn the power head over.