75319-10 REV A S I M P L Y A M A Z I N G® USER’S GUIDE 2005HH 2005RH COMMERCIAL HIGH SPEED UPRIGHT VACUUM CLEANER WITH ® CLEANING SYSTEM •IMPORTANT• SAVE THIS BOOKLET! Includes: • Safety Warnings • Warranty • Operating Instructions • Trouble Diagnosis • Accessories
IMPORTANT SAFETY INSTRUCTIONS BEFORE OPERATING CLEANER, READ ALL INSTRUCTIONS IN THIS MANUAL CAREFULLY. When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING Table of Contents Plug Fitting Instructions, Important Safety Instructions . . . . . . Maintenance and Customer Service, Warranty, Accessories . . . . . . . . . .
Accessories Maintenance and Customer Service (Sold Separately) ITEM Your ORECK vacuum cleaner is a product of precise engineering. The motor bearings are permanently lubricated and should not be oiled. If you require additional information or have problems with your ORECK appliance, or to order new bags or spare parts, you may call ORECK customer service at: (0) 01279 406995. Dust Bag, 9 Pack Hypo-Allergenic PK80009DW Regular PK80009 2. Belts, 3 Pack 0300604 3.
To Replace Filter Dust Bag Assembly To assist you in assembling your cleaner, the parts have been numbered as follows: 1 Handle section, upper 2 Tube, lower 3 Power head 4 Outer bag 5 Paper filter dust bag 5 6 Power cord 7 Retaining spring 8 Bag tension bar 9 Zip fastener 10 On/off switch 11 Cord hook 12 Plastic loop/cable clamp 13 Connector assembly 14 Fan housing 15 Cord assembly 16 Handle Brace 17 Cord Strain Relief WARNING: Unplug cord from electrical outlet before servicing.
Operating Instructions To Operate Make sure the disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet. Press the ON(l) - OFF(O) switch on handle assembly when ready to operate. All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner.
How to Replace a Worn Belt Operating Instructions WARNING: Unplug cord from electrical outlet before servicing. CAUTION—WOOD FLOORS, SOFT (VINYL, ASPHALT TILE, ETC.) FLOOR SURFACES AND POLISHED FLOOR FINISHES Use floor and floor finish manufacturer’s recommended methods of cleaning. The metal strip on the base of the cleaner could be damaged if used on concrete or abrasive surfaces, and, therefore, cause damage to wood floors, soft Remove the replacement belt from the storage channel.
To Adjust or Replace Brush Stuffing or Blockage WARNING: Unplug cord from electrical outlet before servicing. Under certain conditions it is possible to stuff or block the intake tube and the lower tube assembly. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow the following steps: To determine if the brush is worn, place a firm straight edge across the nozzle opening.
Troubleshooting Guide Stuffing or Blockage 5. Many times blockage occurs due to a full dust bag causing dirt to back down the air flow system. When that happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly. See illustration F. WARNING: Unplug cord from electrical outlet before servicing. F Connector Deflector Opening SAVE SERVICE CALLS...
