Instructions

How do you like them apples?
Thank you for your support!
Starkrimson® Mono Instructions
Note:
Do not power or operate amps without speakers connected.
Do not plug a live power supply into the amplifier.
Due to the bridged amplifier design both speaker terminals are hot when the amplifier is on.
• Warning - High Voltage
• Do not connect either speaker terminal to GND or EARTH
No user-serviceable parts – tampering with the amplifier will void the warranty
For best performance place the amp(s) as close as possible to the speaker(s) and use
very short speaker cables.
To turn the amp on:
1. Connect Speakers
2. Connect Input (XLR or RCA with adapter)
3. Plug-in power supply into the amplifier (power supply needs to be off; the green light is
off)
4. Plug-in power supply into AC outlet
To turn the amp off:
1. Unplug from the AC outlet and wait at least 5 minutes for capacitors to discharge
2. Remove other connections
Improper powerup or power down of the amps may cause damage and this damage will not be
covered under the warranty.